Blyss BLY1 Spezifikationen PDF herunterladen (Seite 10)

Installing your System

BLY1 Wireless Alarm System

Getting started...

Installing the Control unit

• Remove and retain the

two holding screws

from front cover of

control unit and

carefully hinge off

the front cover.

Fitting

• Place the

control unit

base mounting

plate on the wall at

the chosen location.

Mark and drill 4mm

holes for the two

mounting screws. Insert

wall plugs and have

the top mounting screw

screwed in to protrude

by about 5 to 6mm before hanging the control unit base mounting plate on wall.

• Align the control unit base mounting plate to vertical position before nal tightening of both

mounting screws.

Powering the Control unit

• Wire up the Main Power Adaptor to

the control unit, but DO NOT plugs the

adaptor into the main supply at this stage.

• Do not install the 9V back up battery

(provided with this kit) at this stage, but note its

installation position for later.

• Put back the front cover carefully and secure it

with the two holding screws, complete with the

screw covers (plugs).

• Power up the Main Power Adaptor to power

the control unit. The POWER LED will light up

and the TAMPER LED will ash since no

backup power is installed yet.

• If the alarm sounds then enter the factory user

PIN 1234 to silence the system.

Hole depth ˃22mm

Battery

Cover

Battery Clip

Battery

Compartment

External 15V

Adaptor

From External

15V Adaptor

Base Mounting

Plate

Control Unit

6LR61 size

9V alkaline

battery

2 Pieces of M3 x 10mm

retaining screws

WARNING: The control

unit must never be

operated from the mains

with the front cover

opened. The user PIN

code is factory set to 1-2-

3-4. If the system sounds

during the installation,

pressing the factory set

code of 1-2-3-4 will silence

the system.

ST3x25KA

screw

5~6mm

protrude surface

Base Plate

2.6mm thick

98mm

Tighten the

screw to

fasten the

base plate on

surface

Wireless Alarm System.indd 10 01/06/2012 10:57

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Blyss BLY1 Spezifikationen Seite 10

Kommentare zu diesen Handbüchern